River walleyes can be found in shallows
Unlike in lakes, where larger walleyes often are found in deeper waters than their smaller counterparts, bigger river walleyes often set up in the shallows, especially when actively feeding.
This is particularly true when the water is high, as it has been much of the time in Western Pennsylvania.
A couple of instances that took place last weekend illustrate how walleyes use the shallows.
Last Saturday, Andy Vetula and I fished the Allegheny River near East Brady, figuring the high water should concentrate the walleyes and muskies. One of the first spots we fished was a deep slot along a boulder-strewn bank that ended where a shallow rock bar bisected the river. A swirling wind made boat control difficult, however.
A combination of dead weeds and fallen leaves collected in the eddy formed by the rock bar, complicating the process of pitching jigs up to the bank.
Just as the wind caught the boat and tried to push it around, Vetula set the hook into a chunky river walleye, a fish that measured 22 inches. The effort of fishing in the 30 mph gusty winds didn't seem quite as difficult after that.
The following Sunday, I fished in the Oil Region Alliance Allegheny River Classic Bass Tournament near Franklin.
When the weigh-in activities were finished, Butler's Aaron Dickey, who had participated in the tournament, asked if he could have a walleye weighed in.
Earlier in the day, Dickey had caught the walleye in about three feet of water on a tube jig. The trophy walleye weighed 11.76 pounds and stretched the tape a tad over 31 inches. Not only does Dickey's fish help illustrate how shallow big walleyes will hold, but also the fact that walleyes will readily eat tube jigs.
Tubes typically are thought of only as bass lures, but they are an excellent walleye bait as well.
River walleyes are river walleyes, and they act much the same regardless of the system that is being fished.
During the late fall through winter, Minnesota guide Steve DeZurik typically targets the Mississippi River shallows, pitching jig-plastic combos.
"We use a lot of 4-inch Yum ringworms on one-sixteenth to quarter ounce jigs," said DeZurik. "A quarter ounce is as heavy as we go. The lightest we can get away with, the better."
DeZurik stays with the leadhead-ringworm presentation as long as the water stays clear. When the river begins to rise and color, he switches to a hair jig presentation.
"It's a real finesse approach," he said. "Pitch the jig up along the shallows below the tailrace area, targeting the current break where the flat drops off into the deeper channel. It can be a sand or gravel structure, or a wingdam.
"The active fish will sit right up on the shallow side of the break, as long as they have the deep water nearby," DeZurik added.
The shallows DeZurik speaks of runs about 8 to 10 feet or less.
"It's a big-fish pattern during the cold water period," said DeZurik. "I'll either anchor or hold the boat with the bow mount trolling motor. You will be able to see these current seams. It's very visual. Pitch casts are made to very specific spots."
DeZurik said the key to the pitch cast is a tight line. Make a cast to the current seam, allow the jig to settle, then pick it up about 2 feet without dropping the rod tip. This allows the bait to slowly swim toward you. About 99 percent of the hits will occur during this slow, swimming drop.
