Go against current when targeting walleyes
Our region offers top-notch fishing for river walleyes. The best will come shortly, when the water cools and walleyes concentrate in well-defined locations.
Professional walleye angler Greg Yarborough isn't afraid to buck the current of the river — or the tradition of fishing only with the current — when presenting jigs to walleyes. It is part of a system he often uses on rivers throughout the season.
"When I go to prefish a river for an event, pulling jigs upriver is one of my starting strategies," said Yarbrough of Port Clinton, Ohio. "I can cover water, locate key structure where the fish are holding, move in and out to find different depth levels. I can cover a lot more water than by just vertically jigging with the current. I can be a lot more precise."
Not only does Yarbrough's approach minimize his chances of spooking fish, since he's not motoring back up through a school with the outboard, it also maximizes the efficiency factor. He can allow the boat to slide from side to side, all the time fishing. He can stall the boat's forward progress and hover in place if so desired.
"I'm a big believer in keeping your lines in the water as much as possible during the day," he said. "Time is of the essence when you are in a tournament situation. But even if you are not tournament fishing, you want to make the most of your opportunities."
Throughout the season, river walleyes inhabit a wide variety of habitats. During the cold water period, slack water pools attract fish looking for areas where they don't have to fight the current. In warmer water, current is not so much an influencing factor in fish location. Regardless of season or habitat, some holding spots are large while others are more defined. Yarbrough has found upriver jigging to be an effective tactic in the many settings river walleyes inhabit.
"I use my Minn Kota Autopilot to keep my speed just above being pushed back, just enough to keep moving forward," explains Yarbrough. "I try to use just my electric as much as possible, especially in shallow water situations. I feel that is really critical.
"I fish a lot of 4- to 8-foot depths early in the spring and again late in the fall. If you are out in deeper water and you have strong winds, when working deep flats or contours, sometimes it's necessary to use the kicker motor to assist with the thrust and to use the Minn Kota Autopilot as the bow thruster and a way to control the boat better, to stay on the contour better."
If pulling a jig was a simple as leaving your jig in the water, reversing the thrust of the motor and fishing your way back upriver, everyone would do it. Obviously, it's not that easy.
Adjustments must be made regarding jig weight, as well as the angle of the line to the water. In vertical jigging, you can fish directly under the boat if you wish, something that is not going to happen when you reverse the field and start back upriver.
"In shallow water, when I'm jigging downriver, I stay as light as possible," says Yarbrough. "One-eighth- or three-sixteenths-ounce leadheads the majority of the time, quarter-ounce at the most. When I make that pull back upstream, bump that up a couple of notches."
Yarbrough uses a 45-degree of angle to help determine the proper jig weight. As he inches his way upriver, if the angle of the line to the water is about 45 degrees, the weight is right. An angle significantly greater than this indicates too heavy a jig, while the opposite is true if the angle stretches out well less than a 45.
When working in concert with downriver jigging, then pulling back upriver, Yarbrough takes a two-fished approach, tackle-wise. He uses spinning tackle when slip-drifting downriver, then switches to casting tackle for the ride back upriver.
